Parts
(A) screw), (B) tongue, (C) fastener, (D) lock
STEP 1. Remove the screw (A), the tongue (B), and the fastener (C) from the back side of the key lock.
STEP 2. Drill a 12mm hole in the specified mark at the back of the handle.
 
STEP 3. Insert the lock from the front side of the hatch (Pic 3a).
Attention: The lock is made of 2 pieces, the tube (D1), and the locking mechanism (D2) (Pic 3b). Since these are not attached together, you must be careful in handling, so that you do not lose the latter during installation.
3a. 3b.
STEP 4. Holding the lock in place with one hand, place the fastener from the back side of the hatch, with the other. Fasten till the end.
STEP 5. Place the tongue from the back side of the hatch.
STEP 6. Fasten the screw from the back side of the hatch.
Attention:
When placing the tongue make sure that the handle is in the lock position, and that the tongue is facing towards the centre of the hatch’s locking system. These are the correct open (pic 1) and close (pic 2) positions.
1. 2.
If you place the tongue any other way it will not lock firmly (see pictures 3 & 4).
3. 4.
| 
General Marine Equipment
